By default when the CD-ROM driver is loaded, it’s designated as Drive R. Restart the VM and you should see the following. You won’t be able to boot up with the CD alone.
With the VM created, you may start it and mount both the Windows 95 floppy boot disk and the Windows 95 CD whether it be via physical drive or image file. USB > Deactivate the USB controller (if you’re using a release prior to OSR 2).Network > Adapter 1 > Use Bridged Adapter and ensure it’s a PCNET-Fast III.Audio > Audio Controller > Use Sound Blaster 16.Display > Scale Factor > Default is 100%, useful for enlarging low resolution output on our modern resolution displays if desired.System > Acceleration tab > Deactivate the VT-x/AMD-V and Nested Paging.Retail and OSR 1 set the size no longer than 2GB, otherwise you may increase.īefore continuing, check that the following settings are in place for this VM: Again as I’m using OSR 2.1 I’m going to increase it to 6.4 GB, an accurate size for a physical hard disk in the late 1990s. If you are using the OSR 2 or later release you may increase above this as these support the FAT32 file system. If you are using the very original version of Windows 95 (the retail version) or OSR 1, it’s recommended to keep the disk size at 2 GB. Select VDI (VirtualBox Disk Image) and Dynamically allocated over the following couple of options before choosing the size of the hard disk. Again as we’ve chosen Windows 95, VirtualBox has suggested the recommended size of the hard disk to be 2 GB. As we don’t have one yet, we will select the Create a virtual hard disk now option and choose Create. Now the option is regarding a hard disk for the VM. A historically accurate amount was typically in the range of 8 MB to 32 MB. By default as Windows 95 had been selected, the recommended memory size is 64 MB. Windows 95 will run on the lowest option of 4 MB, though won’t be satisfactory. The following option now is to choose the amount of RAM. You may either select the Windows version as shown below, or type Windows 95 and the drop-down selection will automatically change. A Create Virtual Machine dialog box will appear allowing you to select which operating system it will be using for this virtual machine (VM). SciTech Display Doctor 7.0 Beta DownloadĪs I’ve covered a little more detail in setting up a virtual machine in VirtualBox with Windows 3.1, I’ll be skipping over some of the details and be more straight to the point here.